Diamond-products CC1600 Manuel d'utilisateur

DIAMOND P R O D U C T S WALL SAW OPERATOR’S MANUAL MODEL CC1600 Part #: 1800745

Chapter 4 OPEARATING THE SAW NOTE Ensure the saw is properly set up and ready for operation in accordance with Chapter 3 of this manual. CAUTION

2. All cuts must be made in steps. The first cut should be 2-3” deep. Each following cut can add up to 6” depth until the wall is cut through or t

Chapter 5 TROUBLESHOOTING 1. If your saw does not operate properly, the following table may be used as a guide in diagnosing and eliminating the pro

Saw does not move past track joints. Tracks are not aligned. Tracks are warped. Saw rollers too tight. Mount tracks correctly, using jack screws to

Chapter 6 MAINTENANCE Proper preventative maintenance is essential to ensure a long service life, minimize downtime for repair and provide for safe,

TABLE 4 CAPACITIES AND RECOMMENDED SPECIFICATIONS Recommended Specifications Capacities Location of Use Motor Oil

333 Prospect Street, Elyria, Ohio 44035 (440) 323-4616 • (800) 321-5336 • Fax (440) 323-8689 www.diamondproducts.com Printed in U.S.A.

Table of Contents Description Page No. Chapter 1 – Safety ………………………………………………………………………….. 3 Personal Safety…………………………………………………………………

Chapter 1 SAFETY Your Diamond Products CC1600 wall saw has been designed to be as safe and efficient as possible. However, wall sawing can be hazardo

GENERAL SAW SAFETY • Never leave the saw unattended while running. • Do not exceed the rated pressure of hydraulic components. If you are unsure, c

Chapter 2 TECHNICAL DATA DIMENSIONS 15.818.46.41.03.66.417.316.811.4 WEIGHT Saw only (1:1 blade drive ratio) 87 lb. (37.2 kg) Saw

TABLE 1 SUGGESTED BLADE SPEEDS BLADE DIAMETER OPTIMUM RPM MAX SAFE RPM (D-P BLADES) GPM 3.80 CU IN MOTOR GPM 5.20 CU IN MOTOR 18” 2100 3400 30 24

Chapter 3 WALL SAW SET UP INSTRUCTIONS MOUNTING THE TRACK 1. Locate the cut line on the wall. WARNING! Before cutting or drilling, be sure there a

To adjust the rollers: loosen the set screw, rotate the roller assembly with a 1-1/2” wrench until the roller is in contact with the track, then tigh

MOUNTING A FLUSH CUT BLADE NOTE Always use a flush cut blade guard when flush cutting and a standard style blade guard for all other cutting. 1. Rem