Diamond-products Dragon Saw Blade Manuel d'utilisateur télécharger pdf

Blade removal and installation

Step 1: Remove blade guard and splash flap using 9/16” wrench provided (figure

1).

Figure 1

Step 2: Remove adjustable arm assembly (figure 2).

Figure 2

1 2 3 4 5 6

Page 1

Blade removal and installation Step 1: Remove blade guard and splash flap using 9/16” wrench provided (figure 1). Figure 1 Step 2: Remove adjustab

Page 2

Blade removal and installation Step 3: Relieve transmission assembly tension by pulling t-handle out and turning 90 degrees (figure 3) Figure 3 St

Page 3

Blade removal and installation Step 5: Hold transmission in neutral position and remove upper drive wheel and blade (figure 5). Figure 5 Step 6:

Page 4

Blade removal and installation Step 7: Inspect lower drive roller for wear on lip. Replace if lip is worn to half the original width (.200”)(figure

Page 5

Blade removal and installation Step 9: With the transmission assembly in neutral position, reinstall upper drive roller using the ¼” allen wrench pro

Page 6

Blade removal and installation Step 11: Reinstall adjustable arm assembly, blade guard and splash flap on saw. Hand tighten bolts. Place ring saw o

Pas de commentaire

Diamond-products Dragon Saw Blade Manuel d'utilisateur