Diamond-products CC155 Manuel d'utilisateur télécharger pdf (Page 19)

CC155 Green Concrete Saw Manual

Maintaining the CC155

Failure to read and comply with the maintenance

instructions provided in this manual may result in

serious injuries and/or death, and may harm the

saw. DO NOT attempt to perform maintenance on

this saw if you are not properly trained for it, or are

not supervised by an experienced person.

Refer to the Diamond Products’ Parts List for

additional information and part diagrams when

performing maintenance tasks. Refer to the engine

manual and manufacturer as the primary source for

all safety, operations, and maintenance instructions

for the engine. All non-routine maintenance tasks

should be performed by an authorized service

center. Contact the manufacturer with any

additional questions.

Tasks Prior to Maintenance

Complete the tasks listed below prior to performing

saw maintenance:

• Turn off the engine and let the saw cool down.

• Turn off all switches and controls.

• Move the fuel shutoff lever to the off position.

• Raise the saw to a proper height for easy

access when working underneath the saw, and

place jack stands or blocks under the frame

edges at the front and back of the frame base.

• Remove guards and access panels for easy

access.

Maintenance Overview

Complete the following maintenance tasks as

required. DO NOT delay maintenance! Print the

Daily Maintenance Task Chart from the Index to

keep track of the maintenance tasks completed.

Daily Tasks

• Lubricate the blade shaft bearing grease

fittings.

• Inspect the skip plate for damages and clean,

repair, or replace as necessary.

• Level the skip plate mounting flange as

necessary.

• Inspect the belts after the first four hours of use,

and then daily for tension and wear. Replace or

re-tension as necessary.

• Inspect the saw for damages.

• Tighten loose nuts and bolts.

• Check the fuel level and fill as necessary.

• Check the engine oil level and fill as necessary

(see engine manual).

• Wipe down the saw’s exterior.

• Wipe down the engine exterior and guards.

• Look for fluid leaks.

Weekly Tasks

• Clean the air filter (see engine manual).

Note: Refer to the engine manual and manufacturer

for a full maintenance schedule and additional

maintenance information

Handlebars

The handlebars generally require little or no

maintenance and, when used correctly, should

remain in good, working condition. Inspect the

handlebars occasionally for bending, unusual

cracks, and/or breakage. Replace them

immediately when damaged.

Part Lubrication

WARNING

• DO NOT grease parts

with the engine running

unless stated otherwise.

Lubricating parts on schedule increases the saw’s

efficiency and life. Use NLGI No. 2 premium

lithium-based grease when lubricating parts.

Blade Shaft

Lubricate both blade shaft bearing grease fittings

daily. Always grease the fittings with the engine

running at idle (extremely low speed!). Use one-half

to one full pump of grease when greasing the blade

shaft fittings.

Skip Plate and Skip Plate Mounting Flange

The skip plate prevents spalling while cutting. The

skip plate mounting flange holds the skip plate in

place. Inspect the cutting slot and the concrete side

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Diamond-products CC155 Manuel d'utilisateur Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Diamond-products CC155